Lever arm for ECAM and ETAM steaming unit

The brewing unit ejector lever arm (part no. 5313213191) is a plastic component located in the upper section of the brewing unit on DeLonghi ECAM and ETAM coffee machines. After extraction it pushes the spent coffee puck out of the brewing unit and into the grounds container. If the puck remains stuck in the unit, falls out wet and crumbled, or the lever sticks during its travel, these are the typical signs of a worn or damaged lever arm. This is the correct replacement part to restore reliable puck ejection.

Important — verify your model: before ordering, check the exact model designation and variant of your machine (for example the full series code and suffix such as EX:4) on the rating label. The label is usually on the underside of the machine or behind the water tank. This is the only way to confirm that this part will fit your appliance precisely.

When does this part need replacing? (Fault symptoms)

This part typically fails when you notice one or more of the following symptoms:

• The coffee puck remains in the brewing unit and does not drop into the grounds container
• The ejected coffee residue is wet and crumbles apart — a soggy heap rather than a firm puck
• The lever in the upper section of the brewing unit moves stiffly, sticks, or fails to return to its correct position
• Water accumulates in the grounds container and the residue is not properly pressed out and expelled

Compatibility: Which models does this part fit?

This part is compatible with the following coffee machines:

DeLonghi ECAM Series

• DeLonghi ECAM series bean-to-cup coffee machines

DeLonghi ETAM Series

• DeLonghi ETAM series bean-to-cup coffee machines

Note on exact compatibility: the product data states compatibility at ECAM and ETAM series level rather than listing specific model codes. Always cross-reference the model designation from your rating label (for example ECAM 22.110.SB or ETAM 29.660) before ordering, and if in doubt contact our technical support team to confirm fitment.

Original vs. compatible part

Brewive supplies part no. 5313213191 as a functional replacement for the brewing unit ejector lever arm on DeLonghi ECAM and ETAM machines. Before fitting, we recommend inspecting the condition of the spring (product no. 6113210131) that works in conjunction with the lever arm, to ensure the full ejection mechanism is restored to correct operation.

Delivery and returns

The part is in stock with dispatch within 24 hours from the EU, and expert technical support from our service technicians is available. An unused and un-installed part may be returned within 14 days under the statutory right of withdrawal.