Cover for water tank Jura ENA 4 and ENA 8

Looking for a replacement for a cracked or scratched water tank cover on your Jura ENA 4 or ENA 8 coffee machine? This part is designed specifically to replace the original cover, which may have been damaged by a fall, wear, or no longer sits properly on the tank. It is the correct replacement for the listed ENA series models.

Important — check your model: before ordering, confirm the exact model and version of your coffee machine on the rating plate. On Jura coffee machines, the rating plate (with the model designation and serial number) is usually located on the underside of the appliance or behind the water tank. Make sure you have the ENA 4 or ENA 8 model so the part fits correctly.

When does this part need to be replaced? (Signs of failure)

You typically need to replace this part when you notice any of the following:

• The water tank cover is cracked or chipped after a fall or handling
• The cover is scratched, dulled, or visually damaged and detracts from the appearance of the coffee machine
• The cover doesn't sit properly on the tank, comes loose, or holds only with play
• The original cover has been lost or is missing, leaving the tank unprotected

Compatibility: Which models is this part for?

This part is compatible with the following coffee machines:

Jura ENA series

• Jura ENA 4
• Jura ENA 8

Original vs. compatible part

If you're not sure whether this part is the right one for you, check the model designation on the rating plate and compare it with the list of compatible coffee machines above. Verifying the model before ordering is the surest way to ensure the cover fits your tank correctly.