Brew unit feeder for Jura ENA 4, ENA 5 EA and ENA 8 coffee machines

Is the spent coffee puck falling beside the grounds container, or getting stuck inside the brewing unit? The brewing unit feeder Jura 74082 is a plastic scoop attached to the brewing unit that directs the ejected coffee puck straight into the grounds container. If this part is worn, cracked or deformed, this is the correct replacement part for your repair.

Important — verify your model: before ordering, confirm the exact model and version of your coffee machine on the rating plate (usually on the underside of the machine or behind the water tank). This part is intended for Jura ENA 4, ENA 5 EA and ENA 8 machines — ensure your appliance matches this designation so the part fits correctly.

When does this part need to be replaced? (Fault symptoms)

This part typically fails when you notice one of the following symptoms:

• Spent coffee grounds fall beside the grounds container instead of into it
• The coffee puck remains stuck inside the brewing unit and is not ejected
• Loose coffee grounds accumulate in the area beneath the brewing unit
• The plastic scoop is visibly cracked, broken or deformed

Compatibility: Which models does this part fit?

This part is compatible with the following coffee machines:

Jura ENA Series

• Jura ENA 4
• Jura ENA 5 EA
• Jura ENA 8

Genuine vs. compatible part

Brewive supplies the genuine Jura 74082 replacement part. A genuine part guarantees an exact match with the brewing unit's construction and reliable guidance of the ejected grounds. If you are unsure about your selection, our specialist technical support from qualified service technicians is available.

Delivery and returns

The part is in stock and dispatched within 24 hours from the EU, with specialist technical support for part selection. An unused and uninstalled spare part may be returned within 14 days under the statutory right of withdrawal.