Valve drain for Jura E8, J, Z, ENA, Giga coffee machines

The Jura 69125 drain valve sits at the base of the brewing unit and channels excess water away after the brewing process into the drip tray. If more water than usual is leaking into the tray or beneath the machine, a worn drain valve is the most common cause. This is the correct replacement part for that fault — the new version is supplied complete with seal and inlet nozzle as shown.

Important — verify your model: Before ordering, check the exact model and version of your machine on the rating plate. On Jura machines, the plate carrying the serial number and type designation is normally located on the underside of the appliance — lift the machine and read off the full type code, as the front panel description may not match the actual model. This ensures the part will fit correctly.

When does this part need replacing? (Fault symptoms)

This part typically fails when you notice one or more of the following symptoms:

• Water leaks into the drip tray or under the machine and the tray needs emptying far more frequently than usual
• Coffee flows very slowly, drip by drip, or does not flow at all
• Coffee is weak and watery even though the grinder and ground-coffee dose are set correctly
• Unusual hissing or bubbling sounds come from the machine due to pressure loss during brewing

Compatibility: Which models is this part for?

This part is compatible with the following Jura machines:

Jura E Series (including E8)

• Jura E8

Jura J Series

• Jura J

Jura Z Series

• Jura Z

Jura ENA Series

• Jura ENA

Jura Giga Series

• Jura Giga

The series listed above are derived from the part designation. Because Jura uses multiple versions within a single series, always cross-reference the exact type code from the rating plate before ordering. If you are unsure, contact our technical support team.

Genuine vs. compatible part

This is a genuine Jura replacement part in its new version, supplied complete with seal and inlet nozzle. This gives you confidence in a precise fit and a proper seal without the need to repair the original valve.

Delivery and returns

The part is in stock and dispatched within 24 hours from the EU; our service technicians are available to help you select the correct part. An unused and uninstalled part may be returned within 14 days under the statutory right of withdrawal.