Water level sensor cable 245mm for Philips EP coffee machines

What this part does in the coffee machine

This is the coffee machine's wiring – a wire or flat ribbon cable that connects electronic components or supplies power to individual parts of the appliance. Without a properly functioning wire, signal or electrical current cannot reach where it needs to, and the coffee machine cannot work reliably.

Signs of wear or failure

A worn, kinked, or damaged cable shows itself through unstable power supply, spontaneous shutdowns, error messages, display failure, or the coffee machine not responding at all. Flat ribbon cables typically cause intermittent or completely faulty electronics behaviour without an obvious cause.

Why you shouldn't put off the replacement

Damaged wiring can cause not only loss of function but also an increased risk of short circuits or further damage to the appliance's electronics. Replacing the wire in time prevents bigger and more costly failures.

Selection advice

When choosing a replacement, always check the exact match with your model in the product's compatibility table, as the connector type, cable length, and design vary significantly between coffee machine models.

Compatible with

• EP1220 - CMF Series
• EP2020 - CMF Series
• EP2021 - CMF Series
• EP2030 - CMF Series
• EP2035 Lattego Series
• EP2131 Lattego Series
• EP2136 Lattego Series
• EP2220 - CMF Series