Flowmeter for KRUPS EA

Flow meter MS0A10337 is a sensor that measures the volume of water flowing through the hydraulic circuit of a Krups EA-series coffee machine and sends pulses to the control electronics. If the machine has stopped dosing water correctly, is reporting a flow error, or does not complete a full brew cycle, a faulty flow meter is a common cause. This part is the correct replacement for an original, seized, or scaled-up flow meter.

Important — verify your model: before ordering, confirm the exact model designation and version (type code EA8xx) on the rating label. The label is usually found on the underside of the machine or behind the water tank. Spare parts are ordered by catalogue number, not by photograph or dimensions — only then can you be certain the part will fit correctly.

When does this part need to be replaced? (Fault symptoms)

This part typically fails when you observe one or more of the following symptoms:

• The machine produces too little or too much water — the volume in the cup does not match the setting
• Coffee flows slowly, drips, or does not flow at all, even though the pump is audibly running
• The machine reports a water-flow error or interrupts brewing mid-cycle
• After descaling or a prolonged period of non-use, the flow meter remains blocked by limescale and stops sending a signal to the control board

Compatibility: Which models is this part for?

This part is intended for Krups EA-series automatic coffee machines.

Krups EA Series (Espresseria / Evidence / Barista)

• Krups EA-series automatic coffee machines (verify the exact model code, e.g. EA8xx, on the rating label)

Note on exact compatibility: a precise list of compatible models was not supplied with this part, so we do not list specific codes we are unable to verify. If you are unsure whether flow meter MS0A10337 fits your particular model and version, contact our technical support — we will verify it for you using the catalogue number and rating label.

Genuine vs. compatible part

Brewive supplies this flow meter as a spare part under catalogue number MS0A10337 to match the original component in your Krups EA machine exactly. By ordering with the catalogue number you have the assurance of receiving the correct part and reliable performance within the hydraulic circuit.

Delivery and returns

The part is in stock and dispatched within 24 hours from the EU; expert technical support from our service technicians is also available. An unused and uninstalled part may be returned within 14 days under the statutory right of withdrawal.