Cap/sleeve for the valve pin on the Jura drainage valve

Cap/sleeve for the valve pin on the Jura drainage valve It happens repeatedly that the white plastic cap on the drainage valve pin breaks or cracks. If the cap is defective, the valve no longer works because the metal pin can no longer be properly actuated by the drainage solenoid or drainage motor. Water then runs from the drainage valve into the drip tray instead of through the brew group. The sleeve made of aluminium fits very precisely and can be fitted onto the metal pin on the drainage valve relatively easily and without much force. With this sturdy aluminium sleeve you can easily repair the valve. You save yourself buying a new drainage valve and help the environment through sustainability at the same time. Fitting instructions: Pull the defective plastic cap off the metal pin. Place the new metal sleeve onto the valve pin and tap it on carefully with a (rubber) hammer. Important note: The aluminium cap does not fit the drainage valves with Jura article no.: 73649 and 70175. Instructions for dismantling the Jura drainage valve can be found here: Jura Service Instructions. Scope of delivery: 1x metal sleeve for the valve pin on the drainage valve